The light illuminates in yellow when it warnsof a malfunction with Intelligent Key system. If the warning light illuminates in yellow while theengine is stopped, it may be impossible to startthe engine. If the light comes on while the engineis running, you can drive the vehicle.
service indicator
Beside this, How do you reset the service spanner on a Nissan Juke?
– Turn the Ignition On.
– While the Spanner is flashing. Press and Hold the following Buttons for 5 seconds until the mileage is displayed.
– While the Mileage is displayed. Turn the Ignition OFF.
– Turn the Engine On. The spanner will disappear if the reset is successful.
Likewise, How do you reset the service engine soon light on a 2011 Nissan Juke?
Also, What does the key on the dashboard mean?
You see a key light or car with key symbol on dashboard because the key is lost or damaged, and then the car will not start. Inside key is a unique chip for the immobilizer.
How do you reset the oil light on a 2012 Nissan Juke?
press and hold the “file” button until you see the wrench light begin to blink. when it stops blinking, release the button, and your oil life meter should be reset.
19 Related Question Answers Found
What is D mode on a Nissan Juke?
The Juke benefits from Nissan’s D-Mode set-up that adjusts steering weight and throttle response, and in the Sport setting the car is extremely responsive, with the merest twitch of your right foot sending it forward.
What does the key light mean on a Nissan Juke?
After starting the engine the Key symbol will flash yellow for about 30-60 seconds then go out. The owners manual states that flashing yellow Key light indicates engine running with Key fob outside vehicle. This is not the case. Fob is inside. Manual also states that Key light will flash green if fob battery is low.
What does the car with key light mean?
The red key warning light means there is a security error code. This light illuminates when the vehicle control modules see the ignition turned with a key that is not programmed to the vehicle or when there is an error within the security protocol of the vehicle’s security system.
What does car with key symbol mean?
The red key warning light means there is a security error code. This light illuminates when the vehicle control modules see the ignition turned with a key that is not programmed to the vehicle or when there is an error within the security protocol of the vehicle’s security system.
What does sport mode do Nissan Juke?
In the SPORT mode, the engine and transmission are controlled to set the engine speed higher than in the D (Drive) position. This enhances throttle response for a “sporty” driving feeling. – The SPORT mode automatically turns off if a malfunction occurs. …
Why is my key light on?
The key light is telling you that the key is either not detected, or the key is not recognized. This could be the failure of the key, key battery, or an issue in the anti-theft/wireless control system. … There is likely a procedure for starting the vehicle when the key is not recognized or the battery is dead.
Why won’t my change oil light go off?
To reset the oil change reminder light on your vehicle: Turn the ignition key to the run position, do not start the vehicle. Press the gas pedal fully 3 times within 10 seconds. Turn the ignition to the off position. Wait 10 seconds and start the vehicle.
How do you turn off the engine management light on a Nissan Juke?
– Open the driver’s side door and get into the drivers seat.
– Insert the key into the ignition and turn it a quarter turn so the ignition turns on, but the engine doesn’t start.
– Step on the gas pedal and quickly release it. …
– Wait 10 seconds.
How do I get my change oil light to go off?
Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.
What does service engine soon mean on Nissan Juke?
If the check engine light in your 2013 Nissan Juke starts flashing, that means that the problem needs abrupt attention and your Nissan should be brought in promptly. … This flashing light usually indicates a strict engine misfire allowing unburned fuel to be deposited into the exhaust system.
What does it mean when your oil light stays on?
Low oil pressure means the pump isn’t circulating enough oil, or there isn’t enough oil in the system for the pump to circulate. The oil is important to keeping the surfaces lubricated, so if the oil light comes on and the pressure is low, pull over and turn off the engine.
How do I reset my spanner light?
– Turn the Ignition ON (position 2) but do not start the engine. …
– Press the button on the end of the wiper stalk repeatedly until the spanner symbol and miles to service appears on the display. …
– Press and hold the button.
– The display will now change to the new service interval and start flashing.
Last Updated: 18 days ago – Co-authors : 9 – Users : 6
