Subsequently, What are the two sensors on a throttle body? Among the two most important parts within the throttle body are the throttle body position sensor (TPS) and the throttle body temperature sensor. While they sound similar, they are indeed two individual parts that work together to efficiently mix fuel and air.
How do you test a throttle body? 
Yet, Do you have to reset computer after replacing throttle position sensor? After replacing the throttle body to your engine, if the engine light was on and has a pending code, the code will go away. If the code was a hard permanent code, then the ECM (computer) would need a hard reset.
Will disconnecting battery reset throttle position sensor? You can reset your throttle position sensor by disconnecting the battery and then reconnecting it after a few seconds. This will clear any codes that may be stored in the computer and allow the sensor to relearn its idle position.
How do you reset the throttle position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How do you reset a throttle body?
Once you know that it is, you can reset the throttle position in your car.
…
What Is The Procedure?
- Step 1 – Disconnect the battery. …
- Step 2 – Reconnect the battery. …
- Step 3 – Turn the ignition switch to electric. …
- Step 4 – Press the gas pedal down and fully release. …
- Step 5 – Switch the key to the off position.
How do you reset a throttle position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How do you clean a throttle body without removing it?
Can I clean throttle body without removing it?
How do you reset throttle body?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.
Can I use wd40 to clean throttle body?
Gently spray the WD-40 Throttle Body, Carb and Choke Cleaner down the throttle body and wipe with a cloth to remove any dirt and grime. Repeat the process until it is clean and dry.
Can you spraying throttle body cleaner while running?
Can You Clean Throttle Body While Engine Is Running? Yes. However, the entire throttle cleaning solvent will go into the combustion chamber.
Will a throttle position sensor throw a code?
a faulty tps can set a trouble code in the computer if the voltage value is either not present, sporadic, slow or constant, and this can illuminate your check engine light.
Is there a fuse for electronic throttle control?
The power provided to the electronic throttle actuator is regulated by the actuator relay in the underhood fuse panel. It acts as a switch, sending power to the throttle actuator when it is required.