PopularAsk.net – Your Daily Dose of Knowledge

What do plumbers use to unclog drains?

An auger — also known as a plumbing snake — or flat sewer rod can clear blockages deep in drain lines. Chemical drain cleaners contain a high concentration of lye, bleach or sulfuric acid to soften and break up clogs.

Read the full answer

Sulfuric acid

Beside this, What is the best chemical to unclog drains?

– Best Overall Drain Cleaner: Drano Max Gel Liquid Clog Remover.
– Best Drain Cleaner for Hair Clogs: Liquid Plumr Clog Destroyer + Hair Clog Eliminator.
– Best Enzymatic Drain Cleaner: Bio Clean.

Likewise, What acid do plumbers use to unclog drains?

Sulfuric acid

Also, What is the most powerful drain Unclogger?

– Best Overall Drain Cleaner: Drano Max Gel Liquid Clog Remover.
– Best Drain Cleaner for Hair Clogs: Liquid Plumr Clog Destroyer + Hair Clog Eliminator.
– Best Enzymatic Drain Cleaner: Bio Clean.

What can I pour down a drain to unclog it?

– Start by pouring a pot of boiling water down the drain.
– Next, pour a cup of baking soda and 1 cup water/1 cup vinegar solution.
– Cover with the drain plug and wait 5 to 10 minutes.
– Pour boiling water down the drain again.


18 Related Question Answers Found

 

What can I use instead of Drano?

Using a solution of baking soda, vinegar, and hot water – For more stubborn clogs, a combination of baking soda, vinegar, and hot water may do the trick. Because vinegar is an acid and baking soda is a base, mixing the two will cause a chemical reaction that will create pressure and possibly dislodge the clog.

Can I pour sulfuric acid down the drain?

it is safe to use with plastic piping. Sulfuric acid is very simple to use and will unclog a drain within an hour, usually within seconds if it’s not completely plugged up. Sulfuric acid is naturally occurring and is sewer and septic safe as it is diluted in its journey down your pipes.

What chemical do plumbers use to unclog drains?

An auger — also known as a plumbing snake — or flat sewer rod can clear blockages deep in drain lines. Chemical drain cleaners contain a high concentration of lye, bleach or sulfuric acid to soften and break up clogs.

How do you unclog a drain without Drano?

Baking soda and vinegar To clear the drain, slowly pour a pot of boiling water down the drain, saving about one cup for later. Right after, follow the water with 1/2 cup of baking soda and leave for 5 minutes. Then, pour a cup of vinegar into the drain and let sit for 20 minutes.

How do you unclog a drain quickly?

Pour one cup of fresh baking soda down the drain, followed by one cup of white vinegar. Place a rubber stopper or other sink hole cover over the drain opening. Wait 15 minutes to allow the vinegar and baking soda to unclog your drain, Then take out the drain cover and run hot tap water down the drain to clear the clog.

How does sulfuric acid clean drains?

Acidic drain cleaners usually contain sulfuric acid at a high concentration which turns a piece of pH paper red and chars it instantly. Apart from grease and hair, an acidic drain cleaner containing sulfuric acid can be also used to dissolve tissue paper inside water pipes.

What is a natural Drano?

Homemade #Drano! 1/2 cup baking soda, 1/2 cup salt (put in drain) and then gently pour approx. 1/2 cup of vinegar.

Is sulfuric acid safe for drains?

it is safe to use with plastic piping. Sulfuric acid is very simple to use and will unclog a drain within an hour, usually within seconds if it’s not completely plugged up. Sulfuric acid is naturally occurring and is sewer and septic safe as it is diluted in its journey down your pipes.

What is the best drain cleaner on the market?

– Best Overall Drain Cleaner: Drano Max Gel Liquid Clog Remover.
– Best Drain Cleaner for Hair Clogs: Liquid Plumr Clog Destroyer + Hair Clog Eliminator.
– Best Enzymatic Drain Cleaner: Bio Clean.

What is a good substitute for Drano?

Using a solution of baking soda, vinegar, and hot water – For more stubborn clogs, a combination of baking soda, vinegar, and hot water may do the trick. Because vinegar is an acid and baking soda is a base, mixing the two will cause a chemical reaction that will create pressure and possibly dislodge the clog.

Does sulfuric acid damage pipes?

Because it corrodes metal, sulfuric acid can damage chrome, stainless steel and galvanized steel plumbing pipes. It’s recommended for use only if you have plastic plumbing pipes, and even these can sustain heat damage if you introduce the drain cleaner too quickly or use too much of it.

Will sulfuric acid dissolve roots?

Sulfuric acid works by disintegrating organic matter such as tree roots, rags, soap scum, hair, sanitary napkins, paper, grease, fats, and food residue. Once the organic matter disintegrates, it can be easily flushed by water.


Last Updated: 8 days ago – Co-authors : 6 – Users : 10

Exit mobile version