- Replacing a canister purge solenoid is a pretty straightforward type of job that doesn’t cost too much.
- Expect to pay anywhere from $80 to $200 in total.
- What is this?
- The part will typically cost anywhere from $30 to $120, while the labor costs will be right around $50 to $80.
Subsequently, How long does it take to fix a purge valve? The replacement time for the location next to the fuel tank would take about 1 hour and 30 minutes to 2 hours due to raising up the vehicle and having to remove the spare tire if there is any and to remove the fuel filler neck if its in the way.
Where is purge solenoid located? 
Yet, Why is my check engine light still on after changing purge valve? In most cases, if the purge valve has been replaced and you’re still getting codes related to this component, then it’s going to be a fault caused by the sensor or wiring connected to the sensor. Depending on which code you are getting, it could be a different EVAP component causing your issue.
How do you test a purge solenoid? 
Can you fix a purge valve solenoid?
If you have a broken casing or a faulty solenoid, there isn’t much that you can do and you will have to replace the purge solenoid valve.
What does a purge solenoid do?
In particular, the canister purge valve is an emissions control component that allows the engine intake vacuum to take the exact amount of fuel vapors from the EVA canister into the engine intake manifold. In newer model vehicles the purge valve is electrically operated solenoid controlled by the engine computer.
Can I replace a purge valve myself?
Replacing the purge valve yourself is very doable so you can save a few dollars on labor.
Why is my Check Engine Light still on after changing purge valve?
In most cases, if the purge valve has been replaced and you’re still getting codes related to this component, then it’s going to be a fault caused by the sensor or wiring connected to the sensor. Depending on which code you are getting, it could be a different EVAP component causing your issue.
Can a bad purge valve cause transmission problems?
Can a bad purge valve cause shifting problems? A leaking purge valve can cause a difficult start and rough engine operation after being refilled with vapors from the fuel. The shifting difficulty is most likely not caused by the purge valve.
Can a purge valve be cleaned?
Locate the valve; unplug the vacuum lines and the electrical connector. You can now remove the valve from the car. You can try to clean it without opening it. If that doesn’t work and you have good technical skills, or you want to do a deep cleaning, you could open the purge solenoid valve.
Why is my purge valve clicking?
The purge valve ticking noise is most likely normal and should not be noticed inside the cab when the windows are up. If it is too loud inside the cab, then have the valve replaced. The purge valve may be leaking vapor by it and into the engine when you are refueling.