If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.
To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.
Beside this, How do I get my car out of anti-theft mode without remote?
– Check your owner’s manual. Every vehicle is different. …
– Lock your doors. Getting into the car and locking your doors (assuming you have electric locks) might stop the alarm.
– Turn the car on. …
– Turn the ignition to on and wait. …
– Pull the fuse for the alarm. …
– Pull the wires for your alarm. …
– Disconnect the battery.
Likewise, How do I reset my car alarm without a remote?
– Close all of your car doors.
– Insert one key in the door lock and cycle it to the “Lock” position, and then back to the “Unlock” position two times. …
– Enter your car and insert your key into the ignition cylinder.
– Cycle the key in the ignition from the “Off” position to the “On” position twice in a row.
Also, How do I get my car out of anti-theft mode?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How do you reset theft deterrent?
Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.
22 Related Question Answers Found
How do you reset service theft deterrent?
Step 1: Drivers Door Key Reset Also close and any rear doors such as the trunk, rear hatch and front hood. Lock the car using the drivers side lock and walk away from the car at least ten feet. Wait for fifteen minutes and unlock the door, this should reset the security system.
Is the anti-theft light supposed to blink?
The Anti-theft Light in the dash of your car should flash periodically to show that the system is engaged and active. You have to lock the doors of the car (without it running) for the alarm to engage.
What triggers theft deterrent system?
The theft-deterrent system in your vehicle may be triggered by the following: Key learning (copy of key made) Forced entry alarm (door, trunk, hood) … Charging alarm (electric vehicles only)
Why does my anti theft light keep blinking?
If the theft light is flashing rapidly, you have an issue with the alarm system. (bad key, bad antenae in the key hole, wiring issue) If the car is turning over, but not starting and the theft light is steady, I would check your crankshaft position sensor. … turn the key on nothing no lights on dash .
Will disconnecting battery reset car alarm?
Car alarms rely on the electronic component of the vehicle, and disconnecting the battery should both silence the siren and reset your alarm. Open up the hood, locate the battery, and with a wrench, remove the negative terminal. Then reconnect it after a minute has passed.
Why is my anti theft light blinking?
Some anti-theft lights blink by default ( a small red light near the dash, for example is there to warn off thieves ). If this is some other type of light then disconnect your battery (negative first then positive) for 30 minutes and reconnect in reverse order (positive then negative). This should reset the computer.
How do I get my car out of anti theft mode?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How do I turn off anti-theft system?
To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.
What is the blinking light on my dashboard?
The flashing red light is a security light to keep things safe. There are other blinking red LED lights on the dashboard as well. … Faulty switches or something wrong with the engine can also turn the lights ON. The red light blinking in car is of the anti-theft system.
How do I disable anti theft system?
To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.
How do I reset my car alarm after changing the battery?
Use a wrench to loosen the nut of the negative terminal and remove the wire from the battery. Step 3: Reattach the wire. After about a minute, reattach the wire. This should reset all of your electrical systems including those that power the alarm.
What causes service theft deterrent system?
The theft-deterrent system in your vehicle may be triggered by the following: Key learning (copy of key made) Forced entry alarm (door, trunk, hood) Tilt/inclination.
Last Updated: 13 days ago – Co-authors : 7 – Users : 4