Can I burn old fence posts?

1. ajcc said: Been burning them for last 30 years without any discernible ill effect.
2. Crack on lot of good heat in those.

Thus, How do you fill old fence post holes? Set posts on a 6-inch base of 3⁄4-inch crushed stone to encourage drainage. Then fill around posts with the soil from the holes, minus the topsoil, and packs it down every 6 inches. In sandy soil, mix in gravel so that it will pack more firmly. In clay soil, which doesn’t drain well, pack only gravel around posts.

Additionally How do you burn a wooden post?

Can you burn 20 year old treated wood? Homeowners should never burn any type of pressure- treated wood or preservative-treated wood under any circumstances. The chemicals that are in the most common pressure-treated wood are heavy metals: chromium, copper, and arsenic. Those 3 chemicals may become airborne.

Can you get sick from burning treated wood? Pressure treated lumber is considered hazardous waste by the U.S. Environmental Protection Agency. Burning this wood releases the chemical bond that holds the arsenic in the wood and just one tablespoon of ash from the burnt wood contains a lethal dose of this poison.

What do you use to fill post holes?

Should wood fence posts be set in concrete?

Concrete provides a strong foundation for wooden fence posts, but can rot them more quickly. Setting them in dirt, with or without gravel or crushed rock depending on your soil type, can help the posts last longer before going rotten. You can also use metal fence post anchors to prolong their life.

Is 2 feet deep enough for fence posts?

The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).

Can wood fence posts be reused?

To recap, reusing fence posts as fence posts should only be done if the wood isn’t too old, is sturdy, and isn’t rotten. If it is too old, not sturdy, or part of it had to be removed because of rot then use the wood for decoration or small structures like short fences or garden hose stands.

Can you reuse a cemented post?

Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

How do you make a fence post puller?

Can old fence posts be reused?

To recap, reusing fence posts as fence posts should only be done if the wood isn’t too old, is sturdy, and isn’t rotten. If it is too old, not sturdy, or part of it had to be removed because of rot then use the wood for decoration or small structures like short fences or garden hose stands.

How do you remove wood fence posts from concrete?

1. Step 1: Remove Old Wooden Post. …
2. Step 2: Dig around the perimeter of the posthole. …
3. Step 3: Break up the Concrete Footing. …
4. Step 4: Remove Remaining Concrete. …
5. Step 1: Dig around Posthole perimeter. …
6. Step 2: Insert Prybars. …
7. Step 3: Lever the Footing out of the Posthole. …
8. Step 1: Drill Pilot Hole into Post.